Converters / Adapters
Modbus RS485 to USB converter. Used for connecting Modbus sensors using USB connector of Vutlan monitoring units.
Used for monitoring systems: VT900, VT900DC, VT960, VT960DC
The output signal can meet the RS485 standard, the communication distance of more than 1200 meters, the communication load is greater than 30, the baud rate is less than or equal to 19200BPS, by GB/T17626.4 electrical fast transient burst grade III experimental requirements, GB/ T17626.5 surge (impact) immunity level III test request.
Allows to monitor up to 32 Modbus RTU devices/meters/sensors. Max. a distance of a daisy chain is up to 1000 meters. Each metered value of a Modbus device is addressed individually using input registers and is shown by the system as virtual sensors. You can configure thresholds and icon representation for these elements.
It can be used with VT325, VT335S, VT805, VT825 monitoring systems. Installed inside the monitoring unit. Has an internal termination and by default, it is switched ON (if required can be turned off).
Board is mounted and connected inside of VT325, VT335, VT805, VT825 monitoring units. Allows to communicate with 1-Wire readers or sensors.
Converter of current loop 4-20mA is used for measurement of constant current on 4-20mA from different sensors and converting data into format of IP monitoring system. The system interface allows you to assign the sensor and to introduce the function data conversion.
Product added to compare.